Before First Use
- Charge the device for at least 30 minutes (more information on charging can be found here).
- Perform a Light Sensitivity Test
We highly recommend users perform a light sensitivity test before their first use of the device.
- Place the unplugged device on the inner forearm
- Turn on the device to start a treatment
- Wait till the treatment is done. The treatment will take 3 minutes to complete.
- If your skin feels hot or uncomfortable during the treatment directly stop! You might be sensitive to light.
- The device will automatically turn off after the treatment is done. Remove the device and wait for at least 24 hours.
- Check your skin regularly over those 24 hours, if your skin appears red and/or itchy, the device is unsuitable for you.In the case of light sensitivity, please contact us.
If you do not see any redness or irritation resulting from your light sensitivity test you are ready to begin using Bye Acne!
And don’t forget to take your Day 1 “Before” photo!
Getting Started
- Prior to using the device, make sure it is fully charged.
- Clean the skin that you want to treat. Make sure your skin is completely dry and free of all makeup and topicals before using.
- Make sure the device is unplugged and place the device on the skin.
- Turn on the device and enjoy the treatment.
- Press the on/off button for 1 second to turn on the LED light therapy lamp. You will hear a beep to indicate the device is turned on.
- The device switches off after a 3-minute treatment automatically. You may stop the treatment at any time by pressing the on/off button.
- Take the device off the treatment area.
- If you would like to clean the device, you may use a water-based wipe or a damp clean cloth. DO NOT spray the device directly with liquid or put it under water. Ensure the device is not connected to the power supply when cleaning.
- Repeat these steps based upon the treatment protocol.